Inlet Drive Shoreline Resiliency

Construction of improvements to the existing seawall. The project (precast concrete segmented block wall with concrete cap, stormwater upgrades) shall be completed no later than June 1, 2026. The construction scope of work shall include installing approximately 692 linear feet precast concrete segmented block retaining wall behind (landward) the existing coquina block wall that is located adjacent to Salt Run. The existing coquina block wall cap elevation is approximately 4.5 feet (NAVD88). The new retaining wall shall be constructed to an elevation of 8.75 feet (NAVD88) top of wall and will connect to the existing walls that are located on either end of the project. Additionally, two (2) existing curb inlets and the existing 12” diameter corrugated metal pipe (CMP) with associated stormwater outfalls shall be raised and replaced by 14”x23” elliptical reinforced concrete pipe (ERCP) and retrofitted to include a tidal check valve. Rip-Rap is proposed to fill the gap between the existing coquina wall and the new retaining wall and in areas where the coquina wall is missing. Appropriate transitions from the new wall back to the curb along Inlet Drive are included. Also included is the removal and replacement of a minor section of wooden pier and concrete sidewalk, water service line replacement and electrical service relocation to the pier. Appropriate erosion and sediment control measures shall be utilzed during construction. This solicitation has some or all Federal funding, additional requirements may apply. Question writing due by November 17, 2025, 5:00pm.